Management of parts. Reverse engineering

 

    • Spare parts management.
    • Our technical department is skilled in manufacturing by reverse engineering any parts, especially parts of the valve under increased wear: rods, gaskets, seats, gaskets and seals.
      • Material selection.
      • Strength calculation.
      • Process-engineering design and dimensioning.
      • Optimisation of control valves.
      • Drawing generation in 3D CAD.
      • Creation of welding specifications.
      • Preparation of documentation.
    • Measurement systems, check equipment and specific tools for the detection of any type of micro-geometry of the parts are available. The result is a proper design, so that they are completely interchangeable with the original. Any constructive parameter of the new part (material, heat treatment, surface roughness, etc.) is appropriate to the original part.
    • On request, our technical department shall perform calculations and redesign possible improvements on the damaged item to optimize performance and extend its life.

 

Robrenyo 11-15, Local 4

08014 Barcelona (Spain)

© 2017 LYONSAT All Rights Reserved. Powered By Christian Lyon®